Stratos MS A, Perfect mounting distance for the FRs. This is ,00 mm P2S - suitable for a FRs. This Vernier scale runs right to left - as does the metric scale with increasing distance of P2S. If you are unfamiliar with a Vernier scale, please get accustomed to its operation. The whit … 6. Step 4. Fix the assembly in place by re-installing and tightening the thumbscrew. The thumbscrew need only be very snug by hand tension Step 5 Mount the long stainless steel Locator Pin with the Retic … 5.
Slide the tonearm with the mounted cartridge towards the single alignment spot of the selected tangential curve. It is surrounded by lines to ease adjustment and precise view. The WATS2 uses high quality electrical parts and precision.
Do not connect any power supply directly to the video out. Do not connect the WATS2 with any monitor using a. The WATS2 is. We also. Do not install the WATS2 in a position subject to direct. Sunlight shinning directly onto the WATS2 lens can cause. Select a stable place for installation of the WATS2. Use a support of durable strength around an installation.
Do not move the WATS2 with the cables connected. Before moving the WATS2, always remove the video. After installing into main equipment, if the WATS2 is. If any of the following problems occur when using the WATS2,. An optimal picture cannot be obtained, after checking that all the cables. Smoke or any unusual odor emerges from the WATS2. An object becomes embedded or a quantity of liquid seeps into the camera. Anything unusual occurring to any equipment connected to the.
Disconnect the camera immediately according to the following procedures:. Do not modify the WATS2. A modified camera may not. Using the contents figures below, check to make sure all parts are present. Dirt, water or oil deposits on the CCD will cause an unclear picture on the. Attach the lens cap to protect the lens and CCD from. Use the optional DC plug if the shape or polarity of the DC plug of the power.
Therefore, please keep and read the "Cautions for safety" below for. Do not expose the WATS2 to wetness or high moisture. The WATS2 is designed and approved for indoor use only. The WATS2 is not water-resistant or waterproof. If the. Keep the WATS2 dry at all times during storage and.
Should the camera not work properly, switch off the power. Avoid the striking of hard objects or dropping the WAT-. The WATS2 uses high quality electrical parts and precision. Do not connect any power supply directly to the video out. Do not connect the WATS2 with any monitor using a. The WATS2 is. We also. Do not install the WATS2 in a position subject to direct. Sunlight shinning directly onto the WATS2 lens can cause. Select a stable place for installation of the WATS2.
Use a support of durable strength around an installation. Do not move the WATS2 with the cables connected. Before moving the WATS2, always remove the video.
After installing into main equipment, if the WATS2 is. If any of the following problems occur when using the WATS2,. An optimal picture cannot be obtained, after checking that all the cables. Smoke or any unusual odor emerges from the WATS2. An object becomes embedded or a quantity of liquid seeps into the camera.
0コメント