Your dealer wants you to be satisfied with your new mower. If for any reason you do not understand any part of this manual or are not satisfied with the service received, the following actions are suggested:. Discuss the matter with your dealership service manager making sure he is aware of any problems you may have and that he has had the opportunity to assist you. For further assistance write or E-mail to:.
Connect the switch wires on the mower with the switch wires on the seat. IMPORTANT: When access is required under the seat platform and the seat is equipped with the optional arm rests, make certain to place the control arms in the park brake position out and pivot the arm rests upward before placing the seat platform in the full forward position to prevent arm rest damage.
For general location of the controls described in this section, refer to Figure A three position switch: off, run, and start. A cable is linked to engine throttle for controlling engine speed. Move lever forward to increase engine rpm, move lever rearward to decrease engine rpm.
A cable is linked to manually operate the engine choke. When the lever is in the down position, the choke is in the off run position. When the lever is pulled up, the choke is in the on start position. DO NOT operate the machine with the choke in the on start position. It is not important which fuel tank the mower is using. Levers are used to steer, accelerate, brake and change direction. The mower will not move when engine is on, drive pumps are operating and control levers are in park brake position out.
Clutch, belts or deck could be damaged. The Parking Brakes are applied by moving the control levers from the Neutral Position Figure to an outward position Refer to Figure Each rear wheel brake operates independently of the other.
The deck lift pedal is used to raise or lower the deck. Push on the pedal to raise the deck and then place the deck height locking pin into the desired cutting height hole. In the event of a system failure while mowing, engage both parking brakes to stop or slow mower. Refer to Figure This light comes on when the ignition switch is placed in the RUN position and stays lit until the engine is running and a safe oil pressure is developed. If light comes on during operation, shut engine off immediately and locate and correct the problem.
The mower is equipped with a safety start interlock system consisting of the brake switches, seat switch and blade engagement switch. Check mower safety start interlock system daily, prior to operation. This system is an important mower safety feature. It should be repaired immediately if it malfunctions. The machine incorporates a separate seat switch which will stop the mower engine when the operator is unseated for any reason while the mower is moving or the blades are engaged.
This is a safety feature designed to prevent runaway or accidental entanglement. To inspect the system:. The operator must be on the seat when testing the seat switch.
Set both control levers in the park brake position. Start the engine and allow it to warm up to operating temperature. With the blade engagement switch down and the control levers in the park brake position, slowly raise off of the seat. The engine should continue to run. The engine should stop within two seconds.
If the engine fails to stop when the blade engagement switch is up or one or both of the control levers is in and the operator is off the seat, check the function of the seat switch. If the seat switch is not operating properly is not opening or closing and if the cause cannot be determined, replace the seat switch. The safety interlock system should always function per steps 4 and 5. If it does not function properly, it should be corrected immediately.
Do not operate machine without a properly functioning seat safety switch. If for any reason the operator should become unseated when the neutral switches are disengaged or the blade engagement switch is engaged the engine will stop. The following steps are the correct procedures for starting the engine. If difficulty is encountered, contact the Land Pride Dealer in your area.
Before starting mower each day, perform daily pre-operation checking. Make sure the control levers are in the brake position and blade engagement switch is disengaged. NOTE: Use choke position when engine is cold, or if warm engine fails to start within 5 seconds of cranking.
Insert key in ignition switch and rotate clockwise to engage starting motor. Release key when engine starts. An interval of at least two minutes should be allowed between such cranking periods to protect the starter from overheating and burn-out. Perform test to make sure safety start interlock system is operating properly. As soon as engine begins to run, check to make certain the oil warning light is off.
If not, stop engine immediately and check for the cause. Refer to. The Razor Z safety start interlock system is also designed to protect the operator and others from accidental injury due to unintentional engine starting.
The engine starting motor will not engage until:. Control levers are in the brake position. Blade engagement switch is in the down OFF position. Before stopping the engine, place the control levers in the brake position, disengage the blade engagement, and throttle back to low idle for a couple of minutes; then rotate ignition key counter-clockwise to the OFF position.
Remove the key from switch before leaving the seat. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. Land Pride. When you see this symbol, the subsequent instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it!
Cover photo may show optional equipment not supplied with standard unit. Important Safety Information. Hydro-Drive Belt Adjustment. Land Pride is registered trademark. Printed in the United States of America. Land Pride Important Safety Information. Safety at All Times Thoroughly read and understand the instructions given in this manual before operation. The signal words are:! WARNING Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury, and includes hazards that are exposed when guards are removed.
Table of Contents Important Safety Information. Safety Labels Your mower comes equipped with all safety labels in place. To install new labels: a. Table of Contents Introduction. Land Pride welcomes you to the growing family of new product owners. Owner Assistance The Warranty Registration card should be filled out by the dealer at the time of purchase. If for any reason you do not understand any part of this manual or are not satisfied with the service received, the following actions are suggested: 1.
Table of Contents Section 2: Operating. Ignition Switch 5. Deck Lift Pedal 9. Deck Adjusting Rod Right Deck Cover 2. Blade Drive While every precaution has been taken in the preparation of this manual, Land Pride assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein.
Land Pride reserves the right to revise and improve its products as it sees fit. This publication describes the state of this product at the time of its publication, and may not reflect the product in the future. The illustrations in this manual are not intended for safe and proper assembly or disassembly of equipment.
The illustrations are intended for ordering parts only. All other brands and product names are trademarks or registered trademarks of their respective holders.
Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. Land Pride.
When you see this symbol, the subsequent instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it! Cover photo may show optional equipment not supplied with standard unit. All rights reserved. Land Pride is registered trademark.
Printed in the United States of America. Part No. FLAT 4. Part Description Comments Revision FLAT 8. You can only view or download manuals with. Sign Up and get 5 for free.
0コメント